1 DRAW_BOX
    DRAW BOX

    Used in conjunction with the SET RECTANGULAR command.  Press
    <SELECT> to mark the upper left corner of the box, then move to
    where the lower right corner of the box is to be and press <DO>
    and type DRAW BOX. NOTE:  The box will outline the square you have
    marked off, therefore allow for the extra space.

1 RECTANGULAR_INSERT_HERE
    RECTANGULAR_INSERT_HERE

    Pastes the information from a rectangular cut to the current
    buffer beginning at the current cursor postion as the top left
    corner of the block.  This operation will overwrite anything
    that is currently in the user's buffer and there is no method
    of recovery.  Be careful!!!

1 RECTANGULAR_REMOVE
    RECTANGULAR_REMOVE

    Removes (cuts) a rectangular block of text from the user's current
    buffer.  This operation will remove the block of text and does
    not shift any remaining text within the user's buffer.

1 RECTANGULAR_SELECT
    RECTANGULAR_SELECT

    This begins a rectangular-cut-and-paste operation.  Postion the
    cursor to the upper left corner of the block of text to cut and 
    press the <SELECT> key (after turning rectangular mode on).  Next 
    move the cursor to the lower right corner of the block of text 
    to be cut and press the <REMOVE> key.  To paste this block of 
    text, position the cursor to the upper left corner of the new
    position and press the <INSERT-HERE> key.

1 SET_RECTANGULAR
    SET RECTANGULAR
    SET NORECTANGULAR

    This command turns rectangular cut-and-paste on or off.  When the
    SET RECTANGULAR  command  is  issued,  the SELECT, REMOVE, and
    INSERT HERE keys are redefined to perform rectangular cut and
    paste operations. Rectangles  are  formed  by  positioning  the
    cursor  to  where   the upper-left  corner  of  the  rectangle
    will be and pressing <Select>. Then move the cursor to where the
    lower-right corner should be.  Press <Remove>.

    Rectangular pasting is accomplished (after  cutting  a  rectangle)
    by positioning the cursor to where the upper-lefthand corner is to
    appear and pressing <Insert Here>.

    The rectangular mode also lets you  draw  boxes  very  easily.
    After forming  a  rectangle,  press  <Do>  and  enter the command:
    DRAW BOX followed by <Return>.  A  box  (formed  with  ASCII
    characters)  will surround  the  imaginary  rectangle  you  have
    formed.  If you plan on drawing a lot of boxes,  you  might
    consider  binding  the  DRAW  BOX command to a key.

1 DONT_DRAW_LINES
    DONT_DRAW_LINES

    Turns off the line drawing utility set.

1 DRAW_LINES
    DRAW_LINES

    Turns the line drawing utility set on.  Once the line drawing set
    is activated use the cursor keys to draw forms, boxes, lines, etc.

1 ELIMINATE_TABS
    ELIMINATE TABS

    This command will remove tabs from your file and substitute the
    proper number of spaces to keep the appearance of the document the
    same.  The ELIMINATE TABS command assumes tabs are set every 8
    positions.

1 SET_WRAP
    SET_WRAP
    SET_NOWRAP

    Activates/deactivates word wrapping within the editor.  Words are
    wrapped at the right margin as set by the SET RIGHT MARGIN
    command.